Lanxi Yongfeng Machinery Co

Lianjiang County Sand Washing Wastewater Sedimentation Sludge Treatment Machine Lanxi Yongfeng Machinery Co., Ltd. Sales Hotline , only stops the corresponding motor. At this time, other running parts should be stopped manually immediately. In the automatic state, the operation of each part will be stopped immediately
, the overloaded motor and the cause of the overload will be found and eliminated.
, reset the thermal protection relay corresponding to the overloaded motor.
, restart the machine and enter the normal operation stage.
5. Insufficient air pressure
Insufficient air pressure is mainly manifested by the machine being unable to start under normal conditions, or suddenly stopping during operation. At this time, all switches should be set to the stop position immediately.
, check the scale value of the pneumatic dual-element pressure gauge. If it is less than the scale, it means there is insufficient pressure and the machine cannot start normally.
, check whether the air compressor is running normally and whether there is any blockage in the gas pipeline. Troubleshoot the cause of the fault.
, after the air pressure is satisfied, start the equipment and enter the normal operation stage.
Four daily precautions for sludge dehydrator
When the sludge dehydrator is running, you should pay attention to the operating status of the machine. Such as sludge flocculation effect, mud production effect, filter cloth cleaning effect, etc.
When the machine is running normally, the operating frequency of the filter cloth should be between. The specific operating frequency value can be adjusted according to the mud removal effect.
, the amount of mud should be adjusted well, and attention should be paid to the changes in mud amount and the uniform distribution effect of the distributor to prevent excessive, sudden increase in mud amount, and accumulation of sludge, causing the filter cloth drive motor to stall and Problems such as damage to the filter cloth.
When the sludge dewatering machine is running, the cleaning effect of the filter cloth should be ensured to prevent the filter cloth from being clogged and the water permeability becoming poor. Affects the treatment effect and filter cloth service life.
When the sludge dewatering machine is running, the ratio of the amount of sludge entering and the amount of flocculation added should be controlled. If the flocculation amount is too small, the sludge flocculation effect will be poor, making the subsequent process extremely difficult to handle. Excessive amount of agent will cause sludge to easily stick to the filter cloth, resulting in poor cleaning effect of the filter cloth and affecting subsequent processing.
Do not over-tighten the tensioning spring of the scraper to prevent damage to the filter cloth. After wear, it should be replaced in time to prevent damage to the filter cloth.
According to the frequency of use and running time, add butter to the bearings and add lubricating oil to the pneumatic dual components.
When the sludge dewatering machine ends operation, the filter cloth must be cleaned to ensure the water permeability and service life of the filter cloth. In special circumstances, if the machine cannot operate for a while, high-pressure water guns and other tools should be used in time to clean the sludge in the middle of the filter cloth to prevent the sludge from hardening in the filter press section, causing the filter cloth to become clogged and unable to operate.
When cleaning the dehydrator, pay attention to cleaning the accumulated sludge in the water tray.
, Tools, objects, etc. should be avoided being placed on the machine to prevent them from falling onto the filter cloth and being squeezed during the operation of the machine, causing damage to parts and filter cloth.
Sand washing wastewater sedimentation sludge treatment machine equipment manufacturer for sale
Kaiti_ Company name Lanxi Yongfeng Machinery Co., Ltd.
Kaiti_ Contact person
Kaiti_ Xu Gaofeng
Kaiti_ Contact phone number
KaiTi_
KaiTi_ Contact
KaiTi_
KaiTi_ Address Beside the National Highway, Yongchang Industrial Park, Lanxi City, Zhejiang Province
KaiTi_ (formerly Qixing Machinery, Navigation You can directly guide Lanxi Yongfeng Machinery Co., Ltd. to get there.)